Camera Installation - Idis DC-S6283HRXL Quick Manual

Power
1
Network Port
2
Alarm In/Out
3
Video Out, Audio In/Out
4

Camera Installation

Inserting a SD Memory Card
Insert a SD memory card into the SD memory card slot
with the 'micro SD' print facing upward.
Push the SD memory card until it disengages from
the slot, and then pull it out.
• Make sure that the cover is joined properly
when screwing it; otherwise, the IP66 level is not
guaranteed.
• microSD Logo is a trademark of SD-3C, LLC.
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
• Install the camera in a shaded area. If the
camera is installed in direct sunlight, it may
affect adversely.
1
Make a cable hole in the wall or ceiling.
Bushing
Use a bushing provided with the camera to prevent
moisture or water from entering through the bracket
or pipe. First, pass the cable through the waterproof
bushing, assemble it in the pendant, and then use
the waterproof glue provided with the camera to fill
the cable gap and the holes.
1-1/2" Bracket
Mount Adapter
Pendant
<Installing to the bracket>
2
When installing in 1-1/2" PF bracket, assemble
mount adapter to the bracket and then assemble
the pendant. Hook the safety wire of the camera
on the safety wire ring of the bracket.
The bracket must be purchased separately.
3
Assemble the mount adapter to the camera body
and secure it by using the mount adapter screws
(3 points).
Apply glue
to the gaps
<Installing to the pipe>
Lever
Bushing
Pendant