General Information; Receiving & Inspection - Honeywell Hauck MEGASTAR MS-25 Instructions Manual

This equipment is potentially dangerous with the possibility of serious personal injury and
property damage. Eclipse, Inc. recommends the use of flame supervisory equipment and
fuel safety shutoff valves. Furthermore, Eclipse urges rigid adherence to National Fire
Protection Association (NFPA) standards and insurance underwriter's requirements.
Operation and regular preventative maintenance of this equipment should be performed
only by properly trained and qualified personnel. Annual review and upgrading of safety
equipment is recommended.
A. GENERAL INFORMATION
TM
The MegaStar Burner is the next generation of total air aggregate drying burners. It has the
same quiet operation and ecological benefits as its predecessors, with the improved efficiency,
emissions, and ease of operation. It is available with low pressure atomization for light fuel oils
or LP, and is a highly efficient natural gas or vaporous propane burner. It features our lowest
construction profile allowing for easier installation and easier access to working components on
the burner. Flame adjustability allows a tailored fit to any drum configuration. Air/fuel ratio for the
MegaStar burner can be maintained more precisely than ever before over the entire operating
range by an energy saving VFD for maximum efficiency.
TM
The MegaStar can be supplied with fuel manifolds as an integral part of the burner, or with
optional remote rack mounted fuel manifolds. Natural gas firing does not require a primary air
blower.
The MegaStar
ultraviolet flame scanner. If an alternate flame scanner is
required, consult Eclipse.
B. RECEIVING AND INSPECTION
Upon receipt, check each item on the bill of lading and/or invoice to determine that all equipment
has been received. A careful examination of all parts should be made to ascertain if there has
been any damage in shipment.
If the installation is delayed and the equipment is stored outside,
provide adequate protection as dictated by climate and period of
exposure. Special care should be given to all motors and bearings,
if applicable, to protect them from rain or excessive moisture.
WARNING
NOTE
TM
is supplied with a Honeywell C7027A
IMPORTANT
Page 2
MS-9