Using Color-Coded Scales - RIDGID R4540 Operator's Manual

USING COLOR-CODED SCALES

Each corresponding scale should be used to measure the distance
between the inside face of the blade to the inside face of the fence.
Adjust the width of the table saw by using the table extension.
Release the table "lock" by lifting the extension lock handle
upwards.
BLACK PEG
The black pegs correspond to the black scale with white numbers.
• The black tabs in the middle of the rail can be used for right
rip cut 0 inches to 15 inches.
• To use the black scale with white numbers, insert the fence
notches into the black pegs on the rail.
As seen in Figure 33.
RIGHT ORANGE EXTENSION PEG
The right orange extension pegs correspond to the orange scale
with black numbers.
• The orange pegs on the right of the rail can be used for right
rip cut 10 inches to 25 inches.
• To use the orange scale with black numbers, insert the fence
notches into the right orange extension pegs on the rail.
As seen in Figure 34.
LEFT ORANGE PEG
The left orange pegs correspond to the black scale with orange
numbers.
• The orange pegs on the left of the rail can be used for left rip
cut 0 inches to 12 inches.
• To use the black scale with orange numbers, insert the fence
notches into the left orange pegs on the rail.
As seen in Figure 35.
MAKING ADJUSTMENTS
24
BLACK SCALE W/ BLACK SCALE W/
WHITE NUMBERS WHITE NUMBERS
CLEAR CLEAR
INDICATOR INDICATOR
FIGURE 33
ORANGE SCALE ORANGE SCALE
W/ BLACK NUMBERS W/ BLACK NUMBERS
ORANGE ORANGE
INDICATOR INDICATOR
FIGURE 34
BLACK SCALE BLACK SCALE
W/ ORANGE NUMBERS W/ ORANGE NUMBERS
CLEAR CLEAR
INDICATOR INDICATOR
FIGURE 35