Comfort Glow QDE1350 Owner's Manual page 7

1. Start and select working mode
2. Setting Desired Temperature
OPERATING INSTRUCTIONS
Turn the heater off by pressing the ON/OFF button on the control
panel or by pressing the Power button on the supplied remote
control.
Note: Powering off the heater will stop the heating process only.
The fan will continue to blow for approximately 3 more minutes
to allow for the interior components to cool. The fan will then
turn off automatically.
Select a heat Mode
Press the MODE button to toggle between the three heat modes.
High Mode uses 1500W; Low Mode uses 750W. ECO mode is an
Economic Energy Saving Function. When ECO mode is chosen, the
heater will manage itself from less to more heating power (watts)
in an attempt to maintain a constant warm 68 °F (20 °C).
Adjust the desired temperature by pressing the Up/Down arrows on
the control panel or remote control.
Desired temperature options vary from 59 °F to 86 °F or from 15 °C to
30 °C. Once you have chosen the desired temperature, the heater will
remain on until the room temperature increases to the temperature
on the digital display. The heater will cycle on and off to maintain the
desired room temperature.
Press °C/°F button to change the display temperature between
Fahrenheit and Celsius.
The Fahrenheit indicator LED will light, when the temperature is
displayed in Fahrenheit.
The Celsius LED will light, when the temperature is displayed in Celsius.
7