Advertisement
5. Put the body into
the drain hole through
the bottom of the sink
and screw the collar
back onto the body.
Make sure to push the
collar onto the silicon.
Tighten the locknut
such that it pushes the
gasket up to the
bottom of the sink. Do
not overtighten the
nut.
7. Feed the plug into
the body and align it
with the logo as
desired. Remove the
plug and loosen the
eyehook and adjust
the length so that it
will accept the pivot
arm. Carefully tighten
the eyehook nut such
that the eyehook
keeps its orientation.
350 Dewitt Avenue, Brooklyn, NY 11207 USA T 718.257.2800 F 718.257.2144
MPU7 Pop-Up Lavatory Drain with Overflow
6. Unscrew the
tail from the
body and apply
Teflon tape to
the threads of
the tail. Thread
the tail back
onto the body.
8. Remove the
pivot nut to
access the pivot
washer, then
remove the
pivot washer
from the pivot
nut.
www.watermark-designs.com
Page 3
Advertisement
