Installation In A Double-Hung Sash Window - d2itsu APD-9CK User Manual

Installation in a double-hung sash window

(Note: If the inner width of window is below 20.5"(520mm), please remove the
adjusting panel from window panel and then cut the window panel to make its width
the same as the width of window.)
adjusting panel
1. Install rear clip — aim the rear clip(upper) at the rear clip(lower),fix them together,
press the clasp forcibly in to the groove.
rear connector (upper)
rear connector (lower)
2. Clamp joint B+C into the inner side of window panel along the direction of arrow.
3. Fix the protective grille on joint B+C with screws.
4. Fix the support on the outer side of window panel with nuts, spring washer,
washer and bolt.
window panel
clasp
window panel
joint B+C
screws
cut
inner side
protective grille
23