Table of Contents
Advertisement
LOG PLACEMENT
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only
use the logs supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only
parts specifically approved for this
heater may result in property damage or
personal injury.
Before you begin — Do not handle the log unit with your
bare hands. Always wear gloves to prevent skin irri-
tation from ceramic fibers. After handling the log unit,
wash your hands gently with soap and water to remove
any traces of fibers.
INSTALL EYF24-F LOG UNIT ON BURNER
Figure 18
1. Install Main Log (#1) on middle and rear supports of
base. Tabs should fit inside log center opening. Check
log position and stability.
2. Install Front Log (#2) in front of burner and behind
grate.
3. Rest rear end Top Left Log (#3) in the indention on the
main log. Line up hole in bottom of Top Left Log (#3)
with slot on Front Log.
4. Position rear end of Top Right Log (#4) on indention of
main log. Rest front end of Top Right Log (#4) on front
lot.
PLACE THE DECORATIVE ROCK
DO NOT sprinkle volcanic rock on the logs
or around the pilot or the main burner. This
may cause sooting. Only place volcanic rock
on the floor of the fireplace.
During initial operation of the new heater,
burning logs will give off a paper burning
smell and orange flames will be present.
Simply open the windows for a few hours
to vent the odor.
Monessen • EYF18/24 Gas Log Heater Installation/Owner's Manual • 65D1009 • Rev G • 01/2020
EYF Series Unvented Gas Log Set
Top Left Log
#3
Main Log
#1
Front Log
#2
Grate Bars
Figure 18 -
EYF24-F Log Placement
LG706
EYF24-F logs
Top Right
Log #4
Tabs
LG706
15
Hide quick links:
Advertisement
Table of Contents
