Operation; Control Panel - Zanussi ZFC26400 User Manual

• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator to the Full Loa-
ded position and let the appliance run for 24
hours to allow the correct temperature to be
reached before placing food inside.
Adjust the Temperature Regulator according to
the quantity of the stored foods.
A Temperature Regulator
B Half Loaded position

Control panel

1 2
Temperature regulator
1
Pilot light
2
www.zanussi.com
A
B
C
3
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, espe-
cially at the rear near the heat exchanger. The
materials used on this appliance marked by the
symbol are recyclable.
C Full Loaded position
Switching off
To turn off the appliance, turn the Temperature
Regulator to the "OFF" position.
Temperature regulation
The temperature within the appliance is control-
led by the Temperature Regulator situated on
the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower
settings to obtain the minimum coldness.
• turn the Temperature Regulator toward higher
settings to obtain the maximum coldness.
In case of freezing less food volumes, the
Half Loaded setting is the most suitable.
In case of freezing much food volumes, the Full
Loaded setting is the most suitable.
High temperature alarm light
3
High temperature alarm
An increase in the temperature in the freezer (for
example due to an power failure) is indicated by
switching on of the Alarm light
During the alarm phase, don't place food inside
the freezer.
When normal conditions are restored the Alarm
light will switch off automatically.
35