Installation - Zanussi ZFC26400 User Manual

Problem
Customer Service
If your appliance is still not working properly af-
ter making the above checks, contact the near-
est service centre.
To obtain fast service, it is essential that when
you apply for it you specify the model and serial
number of your appliance which can be found
either on the guarantee certificate or on the rat-
ing plate located on the external right side of the
appliance.
Replacing the lamp
1. Disconnect the mains plug from the mains
socket.

Installation

Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on the
lid, you must ensure that it is made unusable to
prevent young children being trapped inside.
Important! The appliance shall have the plug
accessible after installation.
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar), but for opti-
mum performance install this appliance at a lo-
cation where the ambient temperature corre-
sponds to the climate class indicated on the rat-
ing plate of the appliance:
40
Possible cause
There is no voltage in the mains
socket (try to connect another ap-
pliance into it).
Call an electrician.
2. Replace the lamp with one of the same
power and specifically designed for house-
hold appliances. (the maximum power is
shown on the lamp cover)
3. Connect the mains plug to the mains sock-
et.
4. Open the lid. Make sure that the lamp
comes on.
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
Solution
www.zanussi.com