Behringer ULTRA-DI DI100 User Manual page 3

All manuals and user guides at all-guides.com
5 -20 dB
+
Only use the -20 dB switches if you are sure the ULTRA-DI is clipping (overloading) and not your mic pre-
amp. Always use as little attenuation as possible to get the best possible signal-to-noise ratio.
6 OUTPUT
+
Never connect pin 2 or 3 to pin 1 and never disconnect the shield from pin 1, or the unit will not work on
phantom power.
7 GROUND LIFT
8
2. DI100 CONFIGURATIONS
2.1 Tapping signal from the (Bass)guitar
2.2 Converting the output of a Keyboard / DJ-mixer / Headphone plug
GROUND LIFT ON
Fig 2.1: Guitar ß DI ß Guitar Amp/Mixer
Fig 2.2: DJ-mixer ß 2xDI ß Mixer
E