Controls And Settings - Frigidaire FRWW4543AS Use & Care Manual

CONTROLS AND SETTINGS

Cool Down Period
For best performance, allow 4 hours for the wine cooler to cool down completely. The wine
cooler will run continuously for the first several hours.
Temperature Control for Single Zone Model
Indication of Temperature in Lower Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
Indication of Temperature in Lower Chamber
Indication of Temperature in Upper Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature increase 1°C.
Press this button once to increase temperature 1° F/C.
: Press this button once and the temperature decrease 1°C.
: Press this button once and the temperature decrease 1°C.
Press this button once to decrease temperature 1° F/C.
Indication of Temperature in Upper Chamber
The wine cooler can be operated by adjusting the temperature control buttons (up arrow and
: Temperature display.
down arrow) until the desired temperature is reached.
: Press this button once and the temperature increase 1°C.
The display will flash for a few seconds before set point is locked in.
: Press this button once and the temperature decrease 1°C.
The temperature range MIN and MAX is 41° - 64°F (5° - 18° C).
Temperature display
: Temperature display.
Light: This button turns the light ON and OFF.
Light: Lighting button for LED lamp; it controls the on/off of lamp.
Power: This buttons turns the power ON and OFF.
Power: On/off button used to turn on/off all load.
Notice!
Press both Light and Power button's at the same time to change between Fahrenheit and Celsius
temperatures.
Press Light and Power together for 2 seconds and you can convert b
The default temperature is 10/10°C, and the temperature after power
fahrenheit temperature and Celsius temperature.
• The default temperature for the wine cooler is 54°F (12°C). The temperature after power
failure will be the temperature set before the power failure.
failure will be the temperature set before the power failure.
To elongate the service life of compressor, please wait for at least 5
• To prolong the life of compressor, please wait for at least 5 minutes before the wine cooler is
restarted after power failure.
Notice!
minutes before the wine cooler is restarted after power failure.
Failure display
The default temperature is 10/10°C, and the temperature after
• If "E" and "F" are displayed, please contact local service personnel for repair.
Failure display
failure will be the temperature set before the power failure.
• If the temperature in the cooler is too low, it will display "L".
If there is failure on the sensor, the screen may display failure code, such
• If the temperature in the cooler is too high, the screen will display "H" and will flash. Under
To elongate the service life of compressor, please wait for at
this state, the buzzer will buzz for 30 seconds. One minute later, the buzzer will continue to
as: E and F. When the screen displays the above-mentioned errors, please
buzz for the next 30 seconds. After three times, the alarm will not buzz any more. You can
press any key to cancel sound alarm.
minutes before the wine cooler is restarted after power failure.
do not disassemble it for check by yourself. You should contact local
• Storing too many wine bottles in the cooler may cause the temperature in the cooler to rise
temporarily.
Failure display
after-sales service personnel for repair.
If there is failure on the sensor, the screen may display failure cod
If the temperature in the cooler is too low, it will display "L".
as: E and F. When the screen displays the above-mentioned errors,
When the temperature in the cooler is too high, the screen will display "H"
do not disassemble it for check by yourself. You should contac
8