Frigidaire FRWW4543AS Use & Care Manual page 5

Reversing the door swing
The glass door can be opened from left to right
and vice versa. Should you desire to change the
opening direction, please follow these instructions.

NOTE
All parts removed must be saved to do the
reinstallation of the door.
1. Remove top cap. Remove the three screws
that hold the upper hinge (right side) to
the top of the cabinet. See Fig. 1.
2. Carefully remove top hinge (See
Fig. 1.), then lift the door up off of bottom
hinge and place it on a padded surface to
prevent scratching it. See Fig. 2.
3. Remove the three button plugs from
the upper left corner of the cabinet
and transfer them to the holes on the
opposite side. Be sure to press the button
plugs firmly into the holes. See Fig. 1.
4. Remove three screws that hold the bottom
hinge to lower end of cabinet. Remove the
three button plugs from lower LH corner
and transfer to holes where bottom hinge
was just removed. See Fig. 3.
5. Unscrew pins from both hinges and
transfer to threaded hole on opposite side.
See Fig. 4. Re-install bottom hinge in LH
corner of cabinet using same three screws
removed in Step 4.
6. On bottom edge of door, transfer door
stop bracket and bushing to holes on
opposite side. See Fig. 6.
7. On top edge of door, transfer the button
plugs and bushing to hole on opposite
side. See Fig. 7.
8. Place bottom LH corner of door onto lower
hinge, then install top hinge to cabinet.
Make sure door is level and it seals
properly against cabinet, then securely
fasten three screws. See Fig. 7. Snap top
cap back onto hinge.
Button plugs
Top cap
Screws
Hinge
Hinge
Bushing
Fig. 1
INSTALLATION
Button
plugs
chart 7.
Move pin to opposite hole
Step 13:Assemble the door on the bottom hinge ，then reset the door bolt
(upper and lower hinges)
Fig. 5
Screws
Button plugs
chart 3)
Step 9:Change the hinge axis from the right hole to left hole(se
Fig. 6
Top cap
Screws
Hinge
e g n H i
Bushing
Fig. 7
Fig. 2
Fig. 3
Hinge
Screws
Fig. 4
Chart 7
⑦
Stop
⑧
bracket
⑥
Bushing
Button plugs
5