Put the compressed spring and
7
the square shaft in order, and
mount the safety knob tailpiece.
Insert the outside escutcheon
connecting cable and the motor
cable into the corresponding
sockets, and then insert the
tailpiece and the square shaft
into the two rotary holes on
the mortise, so that the inside
escutcheon is closely fit to the
inside door surface.
Attention
Please hide the extra
cable in the door hole.
9
Install the batteries, and close
the battery cover and the lower
cover of the inner unit. Then
the installation is completed.
8
Tighten the 4 anchor screws.
8
10
Try out the inner and outer
handles, the rotary knob. Try out
the mechanical key. Check if all
parts are properly connected.