Table of Contents
Advertisement
7. TROUBLESHOOTING
7-1. Safety Caution
■ There can be live AC and DC voltage on terminals on the main board, even when the machine is turned off. Be
cautious to avoid electric shock when disconnecting parts while troubleshooting.
(Wear Electro Static Discharge gloves when working.)
■ After cutting off the power when changing the PWB assembly, disconnecting, or reassembling.
■ Be careful static when handling the PWB assembly, and use Electro Static Discharge plastic pack when shipping or
storing it.
7-2. Error Mode Summary
■ If you press the START/PAUSE button when an error is displayed, any error except
machine will go into the pause status.
■ In case of
if the error is not resolved within 4 minutes, power will be turned off automatically and the error code will blink. But in
the case of
, power will not be turned off.
WASHER
■
ERROR
1
WATER INLET ERROR
2
UNBALANCE ERROR
3
DRAIN ERROR
4
OVERFLOW ERROR
PRESSURE SENSOR
5
ERROR
6
DOOR OPEN ERROR
7
HEATING ERROR
if the error is not resolved within 20 seconds, or the in case of other errors,
SYMPTOM
• Correct water level (24.6kHz) is not reached within 8
minutes after water is supplied or it does not reach the
preset water level within 20 minutes.
• The load is too small.
• The appliance is tilted.
• Laundry is gathered to one side.
• Non-distributable things are put into the drum.
• Not fully drained within 10 minutes.
• Water is overflowing.
(water level frequency is over 21.3kHz).
※ If is displayed, the drain pump will operate to drain the
water automatically.
• The PRESSURE SENSOR ASSEMBLY is out of order.
• When water level frequency is consistently below 10 kHz
or over 30 kHz.
• Door not all the way closed.
• Loose electrical connections at door switch and PWB
Assembly.
• The Door SWITCH ASSEMBLY is out of order.
• The THERMISTOR is out of order.
- 35 -
will disappear and the
CAUSE
Advertisement
Table of Contents
Troubleshooting
