Table of Contents
Advertisement
Model 5843 Wireless Speed Trap can be operated with either a
Large Display or a PC or both.
For initial alignment, start with both beams
out of alignment (LED ON). The LED will go
out when the speed or finish beam is in alignment;
once the both beams are aligned, the LED will
pulse when the Speed beam is aligned.
The wireless speed trap requires either a digital
display or a PC with data capture software to
publish the speed trap results. Either method will
utilize a 4520BUSPD unit (internal to the display
or external to the PC - see page 6).
USING DIGITAL DISPLAYS
A 6430/6630/6830 Digital Display will receive
the data to its internal wireless unit and display
the speed. Use the DIP switches to set the speed
trap length, display alignment status, display the
RF signal integrity and set the display hold time
when a speed is displayed.
TYPICAL SPEED TRAP SETUP
modes dependent upon the DIP switch settings.
The 8 DIP switches located on the back of the
Large Display are numbered from 1 to 8 and can be
switched ON or OFF. The ON position is indicated
on the switch itself. Each switch function and
setting are discussed below.
to display the speed before clearing the display.
When race results are displayed, the display will
continue to display the results for the set time. If
the display is sent new race results prior to the set
time expiring, the display will be updated with the
new results and the display hold time timer is reset
to the set time.
RaceAmerica 5843 Wireless Speed Trap
DIP SWITCH DEFINITIONS
The 6430/6630/6830 can operate in different
Display Hold Time
Switches 4 and 5 determine the length of time
6
Advertisement
Table of Contents
