Touch Panel Check - Korg ZERO8 Service Manual

5-2. SW Check
Fig.7 is displayed in the LCD.
Operate the switches like Table 2.
Table2 SW Check
Switches which are checked.
1-8chトtoggle switch"SOLO"→"OFF"→"CUT"
1-8ch [CUE]ｘ2
1-8ch [A][B] each switchｘ2
EXT1 [CUE]
EXT1 [CUE]
EXT1 [CUE]
EXT1 [CUE]
EXT2 [CUE]
ZERO FX [CUE]
[SET UP]
[BPM]
[AUTO]
[TAP]
[A]
[B]
[C]
[D]
1-8ROTARY ENCODER Push Switch
[HOLD]
[CHANNEL]
[SEND]
[MASTER]
6. LCD Check
1. Confirm that all dots of LCD are lighting white.
2. Press the [MASTER].
Confirm that there is not uneven or lack of a dot.
3 Confirm that all dots of LCD are black.
Confirm that there is not a white dot or an alien substance, a scratch inside of the LCD.
4 Press the.[MASTER].
As Fig.8 "#" is displayed in the LCD and it repeats to change light and shade.
Confirm that this changing is normal.
5. Press the [MASTER] to proceed to the next.
７．Touch Panel Check
1. Touch the top left white square of the LCD. (Ｆｉｇ ９)
2. Touch the top right white square of the LCD.(Ｆｉｇ １０)
3.Touch the center white square of the LCD.
4. The white square follows to the point which you touch and move.
・Confirm that that the point you are touching and the white square are same.
・It follows to your moving finger.
・Confirm that when you touch the top left and the bottom right, the white square is displayed.
* When you want to repeat from 1, press the [HOLD].
5. Press the [MASTER] to proceed to the next.
ZERO8 (X-5810) Check before Shipping
LED which lights.
-
[CUE]
[A] or [B]
[CUE]
Meter L Peak LED
Meter R Peak LED
FireWire LED
[CUE]
[CUE]
[SET UP]
[BPM]
[AUTO]
[TAP]
[A]
[B]
[C]
[D]
-
[HOLD]
[CHANNEL]
[SEND]
[MASTER]
No.
Date
Revised
Ｆｉｇ 7 ＳＷ Check
B:Blue
R:Red
O:Orange
Color Notice
- "CUT"side is momentary.
O→B Press twice each.
O→B
Press[A]twice,Press[B] twice
O
R
R
O
O
B
B
B
B
B
B
B
B
B
- Press the knob.
O
O
O
O
Ｆｉｇ ８ ＬＣＤ Contrast Check
Ｆｉｇ ９ After touched the top left.
Fig.10 After touched bottom right.
Fig.11 Touch and move Check
QCI-5810 Page
2007.4.25 3／14
KORG INC.