Troubleshooting - Titan TTB2200PRW-DSS Manual

Troubleshooting

EN
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work must
be performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Oil leak
36
Possible cause
1.1. Not connected to power
supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
1.4. Trigger lock has not
been deactivated
1.5. Nozzle clogged
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e.g.
generator) has too low
voltage
2.3. Air vents are blocked
2.4. Water inlet volume is
too low
2.5. High-pressure hose is
leaking
2.6. Seals worn
2.7. Intake filter dirty
2.8. Air being sucked into
the system
3.1. Seals worn
TTB2200PRW-DSS by TITAN
Solution
1.1. Connect to power
supply
1.2. Contact your nearest
authorised service
centre
1.3. Contact your nearest
authorised service
centre
1.4. Unlock the trigger
1.5. Clean the nozzle
2.1. Use a proper extension
cord
2.2. Connect to another
power source
2.3. Clean the air vents
2.4. Increase water inlet
quantity
2.5. Replace high-pressure
hose
2.6. Contact your nearest
authorised service
centre
2.7 Clean the filter
2.8 Check tightness of hose
fittings
3.1. Seals worn