Eliminating Minor Faults Yourself - Bosch KGN33NWEAG Instructions For Use Manual

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
A warning signal sounds.
Temperature display flashes.
Fig. "/3
The temperature in the
freezer section is too warm.
The side panels of the
appliance are warm.
Possible cause
Fault - the freezer section is
too warm!
Frozen food is at risk.
Appliance is open.
Ventilation openings are
covered up.
Too much food was placed in
the freezer at once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Pipes run into the side panels
which heat during the
cooling process.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
To switch off the warning signal, press
temperature setting button Fig. "/1.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed the freezing capacity.
When the fault has been eliminated, the
temperature display stops flashing.
Do not open the appliance unnecessarily.
Remove obstructions.
Do not exceed the freezing capacity.
That is normal behaviour for the appliance and
not a fault.
Furniture touching the appliance will not be
damaged by the heat.
en
19