Table of Contents
Advertisement
Assembly Cont´d
Assembly Cont´d
Assembly Cont´d
SKID SHOES C6100001 ASSEMBLY (OPTIONAL)
A. Attach rear blade to tractor and level the main
frame.
B. Raise the blade a few inches off the ground by
operating the lift control lever of the tractor.
C. Properly support blade on blocking while installing
skid shoes to prevent possible safety situation if rear
blade were to fall due to lost hydraulic pressure.
D. Remove the two plow bolts from both sides of the
rear blade cutting edge.
E. Mount the two skid shoes (1) to the moldboard
using the two replacement plow bolts (5), lock
washers (7) and hex nuts (6).
7
6
6
7
4
2
4
2
3
1
RB342
4350-2113-00 (Rev. 09/06/04)
F. Insert the skid shoe parking stands (2) through the
skid shoes (1) and stack the fifteen flat washers (3) on
top of each skid shoe parking stand (2) and secure
with klik pins (4).
Adjust skid shoe parking stands (2) to the desired
clearance by taking out flat washers (3) from the top
and placing them on the bottom in between the skid
shoes (1) and the skid shoe parking stands (2).
G. Lower the blade to the ground.
7
3
6
6
7
5
1.
Skid Shoe
2.
Skid Shoe Parking Stand
3.
Flat Washer, 1
4.
Klik Pin, 3/8
5.
Plow Bolt, 5/8 x 2 1/2 GR5
6.
Hex Nut, 5/8
7.
Lock Washer, 5/8
1
5
Assembly
22
Advertisement
Table of Contents
