Table of Contents
Advertisement
Owner Service Cont´d
Blade Cutting Edge
To reverse the cutting edge
1. Remove the 5/8 plow bolts.
2. Remove the cutting edge from the moldboard and
reinstall with the sharp edge down.
3. Replace cutting edge when both edges are worn.
Lubrication
Monthly
1. Lubricate between turn table (2) and offset plate assembly (3).
2
3
RB088
Figure 7. Lubrication Points
Bolts
1. Check bolts periodically to be sure they are tight.
2. Replace bolts as needed.
NOTE: Replacement bolts must have the same
strength markings on the heads. Refer to Bolt Torque
Chart on page 31.
14
Ower Service
4350-2113-00 (Rev. 09/06/04)
Advertisement
Table of Contents
