Bison NVH-150-T Operator's Manual page 20

Assembly Cont´d Assembly Cont´d
Attach Turn Table to Moldboard
C. Secure king pin (10) to the moldboard (4) by using
the king pin cap (21) and castle nut (22). Secure using
cotter pin (16).
NOTE: Remove paint from the moldboard (4) hole
where the king pin (10) goes through if necessary.
Apply grease to all contact surfaces to facilitate
assembly.
4. Moldboard
10. King Pin
16. Cotter Pin, 5/16 x 3
21. King Pin Cap
22. Castle Nut, 1 1 /2
Turn Table Pin Installation
D. Angle the offset plate assembly (3) to one of the
seven positions available. Secure with turn table pin
(7) and safety pin (24) through the holes in the turn
table (2) and the offset plate assembly (3).
Turn Table
2.
Offset Plate Assembly
3.
Turn Table Pin
7.
Safety Pin, 1/8
24.
Figure 10. Main Frame and Turn Table
Figure 11. Turn Table Pin Installation
4350-2113-00 (Rev. 09/06/04)
10
16
21
22
RB091
Installed to Moldboard
7
24
2
3
RB092
4
18
Assembly