Table of Contents
Advertisement
The next step is to select and install a direct drive type P.T.O. to the transmission. Please contact
your local truck equipment representative for the correct unit sized on the following criteria:
P.T.O. Torque Rating:
Power at 1500 RPM:
Output Flange:
Hydraulic Pump Spined Shaft Specifications:
Hydraulic Pump Rotation:
Ratio of Pump RPM to Engine RPM:
NOTE 1:
P.T.O. torque and power requirements are based on the unit operating at main
relief pressure. Normal operating pressure will be less.
NOTE 2:
P.T.O. output rotation will need to be R.H. (clockwise) as viewed looking at
output flange of P.T.O. for a L.H. Pump.
NOTE 3:
Do not operate pump at speeds over 1500 R.P.M.
NOTE 4:
Always disengage the P.T.O. after each operating cycle.
SL-145.INS
09/2009
P.T.O. SELECTION
125 ft.-lbs. (See Note 1)
36 H.P. (See Note 1)
SAE B 4 Bolt
7/8 – 13T 16/32 D.P.
L.H. As provided (See Note 2). The
hydraulic pump rotation can be reversed to
R.H. by a qualified hydraulic technician or it
can be sourced through Swaploader.
80% to 100%
2-12
Advertisement
Table of Contents
