3. Highlight the project in the project list
and press the "OK" button
4. The project is transferred from the
SD/MMC card into the room/control
panel and starts automatically.
5. The units exits the programming mode
automatically and the basic view is
displayed.
Programmi
1. Create the new project on a PC.
ng using
2. Connect the computer with the bus via
the bus
an RS 232 or a USB interface.
3: Press the "EIB Programming Mode"
button and enable it.
4. Start programming from the PC.
This process may take several hours.
ENG
Fig. 69
Fig. 70
45