Table of Contents
Advertisement
Checking the Spark
Arrester
For Machines with a Spark
Arrester
Service Interval: Every 50 hours
WARNING
Hot exhaust-system components may ignite
fuel vapors even after you shut off the engine.
Hot particles exhausted during engine
operation may ignite flammable materials,
resulting in personal injury or property
damage.
Do not refuel or run the engine unless the
spark arrester is installed.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Wait for the muffler to cool.
4.
If you see any breaks in the screen or welds,
replace the arrester.
5.
If the screen is plugged, remove the arrester,
shake loose particles out of the arrester, and
clean the screen with a wire brush (soak the
screen in solvent if necessary).
6.
Install the arrester on the exhaust outlet.
Replacing the
Emissions-Air Intake Filter
Service Interval: Every 500 hours
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the filter from the vent hose.
4.
Insert a new filter into the end of the vent hose.
Fuel System
Maintenance
DANGER
In certain conditions, fuel is extremely
flammable and highly explosive. A fire or
explosion from fuel can burn you and others
and can damage property.
Refer to
Fuel Safety (page 15)
list of fuel related precautions.
Replacing the Fuel Filter
Service Interval: Every 500 hours/Yearly (whichever
comes first) (more often in dusty,
dirty conditions).
Important:
Install the fuel line hoses and secure
with plastic ties the same as they were originally
installed at the factory to keep the fuel line away
from components that can cause fuel line damage.
The fuel filter is located near the engine on the left
front of the engine.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Allow the machine to cool down.
4.
Close the fuel-shutoff valve under the seat.
5.
Replace the fuel filter
Note:
Ensure that the markings on the filter
follow the fuel flow direction.
40
for a complete
(Figure
49).
Advertisement
Table of Contents
