Monte Carlo Fan Company 5GFR52 D Series Owner's Manual And Installation Manual page 5

13
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
16
Light fixture
Finial
Remove finial from light fixture. Keep it.
© 2013 Monte Carlo Fan Company
14
Blade assembly
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
17
Connect white wire from fan to white wire
from light fixture, and then connect blue
wire from fan to black wire from light
fixture.
Loosen 2 and remove 1 preassembled
screw from light plate. Save screw.
Attach light fixture onto the light plate,
aligning the keyhole slots on the light
fixture with the preassembled screws on
the light plate. Twist clockwise till lock.
Reinstall the screw which just removed.
Tighten all screws securely.
15
Light plate
Install light plate onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 14.
Tighten all screws securely.
Note: Make sure the side with a label
"This side up" is installed upward.
18
Install 3 x G9 35 watt halogen bulbs,
Bulbs included. WARNING: Over lamping
the fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed. Reset the lights by turning
off the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
Caution: Do not replace bulb until it
cools down.
5
Bulb
11/5/2013