Maintenance; Operation - Makita DJS130 Instruction Manual

CAUTION:
Do not confound the bearing assembly provided
•
on the tool (thin one) with that for cutting head for
capacity of gauge 16 (Optional Accessory). The
bearing assembly
while that for cutting head for capacity of gauge
16 (Optional Accessory) is thick.
Hex wrench storage
009021
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
009015

OPERATION

009020
provided on the tool is thin
1. Hex wrench
1
1. Hook
1
2
3
009018
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
Adjusting shear blade
1
2
3
4
009019
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold
the cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Lubrication
1
2
3
5
4
009022
7
1. Side blade
2. Side blade
surface
3. Center blade
4. Workpiece
4
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
5
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Lubricate