Wheel Guard For Cut-Off Wheel; Inner Flange; Lock Nut - Makita 9523NBH Instruction Manual

1. Lock nut

2. Abrasive cut-off wheel

3. Inner flange

4. Wheel guard for cut-off wheel

MAINTENANCE
1
1. Exhaust vent
2. Inhalation vent
10
• ALWAYS use guard with wire wheel brushes, assuring
diameter of wheel fits inside guard. Wheel can shatter
during use and guard helps to reduce chances of
personal injury.
Unplug tool and place it upside down allowing easy access
to spindle. Remove any accessories on spindle. Thread wire
wheel brush onto spindle and tighten with the wrenches.
When using wire wheel brush, avoid applying too much pres-
sure which causes over bending of wires, leading to prema-
ture breakage.
Operation with abrasive cut-off wheel
001619
1
(optional accessory)
2
3
WARNING:
4
• When using an abrasive cut-off wheel, be sure to use
only the special wheel guard designed for use with cut-
off wheels.
• NEVER use cut-off wheel for side grinding.
During cutting operations, never change the angle of the
wheel. Placing side pressure on the cut-off wheel (as in
grinding) will cause the wheel to crack and break, causing
serious personal injury.
CAUTION:
• Always be sure that the tool is switched off and
001159
unplugged before attempting to perform inspection or
maintenance.
The tool and its air vents have to be kept clean. Regularly
clean the tool's air vents or whenever the vents start to
2
become obstructed.