Toshiba RAS-07SKSX Service Manual page 51

No. Part name
4
Heat exchanger 1) Remove the front panel, electrical part and
2) Remove the pipe holder at the rear side of
3) Remove the 2 screws on the heat exchanger
4) Remove the screw on the heat exchanger
5
Cross flow fan
To assemble cross flow fan and fan motor to the
unit, please turn the fan motor unit the center of
its terminal meets the top position of band motor
(R).
position where the gap between the back body
and the right surface of the cross flow fan is
4.7 mm.
6
Base bearing
Procedures
the horizontal louver following procedure 3.
main unit.
at the base bearing.
at the fixed plate from the back body and then
pull out the right hand side until the socket of
heat exchanger released from the hook of the
band motor (L), and then pull out the upper
side of heat exchanger slowly.
1) Remove the front panel, electrical part,
horizontal louver and the heat exchanger
following procedure 4.
2) Remove the 2 screws on the band motor (L)
and remove the 2 screws on the band motor
(R) and then remove the cross flow fan.
3) Loosen the set screw of the cross flow fan
then separate the fan and the fan motor.
Notice
Fix the cross flow fan with the set screw at the
1) Remove the front panel, electrical part,
horizontal louver, heat exchanger and the
cross flow fan following procedure 5.
2) Remove the 2 screws fixing the base bearing.
3) Remove the bearing from the base bearing. If
the housing protrudes from the base bearing,
put the housing in position and attach the
bearing to the base bearing.
− 50 −
FILE NO. SVM-07021
Remarks
2 Pipe holder
3
2-Screws
4 Screws
2-Screws (R)
2
2-Screws (L)
2
4.7 mm
6 Set screw
Middle of the fan motor terminal
2
2-Screws