Operation Procedure - Daewoo KOR-86CH9 Operating Instructions Manual

OPERATION PROCEDURE

This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3-pronged 20 Amp, 120V AC 60Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
1
The oven light is on only when the microwave
oven is operating.
2
The oven door can be opened at any time
during operation by pushing the door release
button on the control panel. The oven will
automatically shut off.
3 Each time a pad is touched, a BEEP will sound
to acknowledge the touch.
4 The oven automatically cooks on full power
unless set to a lower power level.
5
The display will show " : 0" when the oven is
plugged in.
6
Time clock returns to the present time when the
cooking time ends.
WATTAGE OUTPUT CHART
• The power-level is set by touching the POWER pad. The chart shows the display, the power level and
the percentage of power.
Touch POWER pad
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
7
When the STOP/CLEAR pad is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all information(except
the present time), touch the STOP/CLEAR pad
once more. If the oven door is opened during the
oven operation, all information is retained.
If the START pad is touched and the oven does
8
not operate, check the area between the door
and door seal for obstructions and make sure the
door is closed securely. The oven will not start
cooking until the door is completely closed or the
program has been reset.
Make sure the oven is properly installed and
plugged into the electrical outlet.
Power level (Display)
P-HI
P-90
P-80
P-70
P-60
P-50
P-40
P-30
P-20
P-10
P-00
7
Approximate Percentage of Power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%