Operation Procedure - Daewoo KOR-611Q Operating Instructions Manual

OPERATION PROCEDURE

This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3 - pronged 15 Amp, 120V AC 60Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
2. The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
The oven light is on only when the micro-
1
wave oven is operating.
2 The oven door can be opened at any
time during operation by touching the
door release button on the control panel.
The oven will automatically shut off.
3 Each time a pad is touched, a BEEP will
sound to acknowledge the touch.
The oven automatically cooks on full
4
power unless set to a lower power level.
5 The display will show " : 0 " when the
oven is plugged in.
6 Time clock returns to the present time
when the cooking time ends.
Make sure the oven is properly installed and
plugged into the electrical outlet.
WATTAGE OUTPUT CHART
• The power - level is set by pressing the POWER pad. The chart shows the display, the power level
and the percentage of power.
Touch POWER pad
Once the Touch
POWER
9
8
7
6
5
4
3
2
1
0
When the STOP/CLEAR pad is touched
7
during the oven operation, the oven stops
cooking and all information retained.
To erase all information (except the
present time), touch the STOP/CLEAR
pad once more. If the oven door is
opened during the oven operation, all
information is retained.
8 If the START pad is touched and the
oven does not operate, check the area
between the door and door seal for
obstructions and make sure the door is
closed securely.
The oven will not start cooking until the
door is comletely closed or the program
has been reset.
Power level (Display)
P-HI
P-90
P-80
P-70
P-60
P-50
P-40
P-30
P-20
P-10
P-0
8
Approximate Percentage
of Power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%