Subscribe to Our Youtube Channel
Related Manuals for Dancover CombiTent PARTY TENT SEMI PRO
Summary of Contents for Dancover CombiTent PARTY TENT SEMI PRO
- Page 1 PARTY TENT SEMI PRO, CombiTent PARTY TENT SEMI PRO, CombiTent 7x12m - Side height 2,3m 7x12m - Side height 2,3m 18-06-2021...
-
Page 2: Safety Advice
Note: Marquees are intended for events and other arrangements and are as such only meant for short term temporary assembly and the following disassembly. Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with written use instructions or manual. - Page 3 Warning The pipes are covered in oil. Before you set up your tent please remove the oil carefully to keep the cover clean. Take note that the tent needs to be handle with care to avoid damages. Do not force the frame as they may be damage in the process. Tents are meant as temporary shelters and must be evacuated under extreme weather conditions.
- Page 4 7x12 -2,3 PARTY TENT SEMI PRO, CombiTent 18-06-2021...
- Page 5 7x12 -2,3 PARTY TENT SEMI PRO, CombiTent CombiTent roof explanied 2m section with 4m section with gable gable 2m section with 2m section without 4m section with gable gable gable 7x10 2m section with 4m section without gable 4m section with gable gable 7x12...
- Page 6 7x12 -2,3 PARTY TENT SEMI PRO, CombiTent Select a flat ground for the tent, unpack the carton and check that all the parts including tubes, tent and accessories… etc. are present same as on the part list. Assemble the framework of rooftop by joining the parts (7, 8, 9-1,9-2, 10-1, 10-2, 11, 12) together with poles (2.3).To ensure the screw fixed to every pole tightly...
- Page 7 7x12 -2,3 PARTY TENT SEMI PRO, CombiTent Attach one end of supported pole (4.5) to the joints(8,11),Strengthen the frame by using screws and turnbuckle set (17). Long screws are used on all connection between 50mm and 54mm pipe. Short screws are used on connection between 42mm and 38mm pipes.
- Page 8 7x12 -2,3 PARTY TENT SEMI PRO, CombiTent Cover the roof on the frame and attach it with the bungee balls. Take care of the Attach all supported poles (1) to the joints (7.10), built-up the framework use the super pegs to fix the poles into the ground. Tighten the frame with the tension of the bungee balls, if you use too many on one side of the tent, it may be turnbuckle set (18).
- Page 9 7x12 - 2,3 PARTY TENT SEMI PRO, CombiTent...
- Page 10 Head office:...
Need help?
Do you have a question about the CombiTent PARTY TENT SEMI PRO and is the answer not in the manual?
Questions and answers