TABLE OF CONTENTS 1. GENERAL INFORMATION…………………………………………………………………..3 1.1 Introduction………………………………………………………………………………..3 2. BOX DESCRIPTION AND TECHNICAL SHEET…………………………………………..4 2.1 General description……………………………………………………………………………4 2.2 Components……………………………………………………………………………………5 2.3 Fabric’s characteristics………………………………………………………………………..7 3. INSTALLATION…………………………………………………………………………..8 3.1 Handling and transport……………………………………………........8 3.2 Place and requirements for the installation………………………………………….….…..8 3.3 Installation………………………………………………………………………………..…….9 3.3.1 Package opening……………………………………………………………………..….….9 3.3.2 Box installation……………………………………………………………………………...
1. GENERAL INFORMATION 1.1. Introduction This manual is an integral part of the product; it is addressed to the installer and to the final user of the box, and enables a correct installation and use. For this reason it must be hold with the box until proper disposal.
1. BOX DESCRIPTION AND TECHNICAL SHEET 1.1. General description The box must be used only as an ordinary protection cover, for purely temporary use. In case of bad weather conditions (wind, snow), the box must be removed. Given that the box can not be fixed to the ground - but only bound to it - its use in these conditions can cause damages to people and things.
NB. Starting from the length (A) of cm 700 (only for mobile version): eyelets placed on the lateral profile for ground-fixation through straps and stakes/ballasts (not supplied by the supplier) 1.2. Components DESCRIPTION ALUMINIUM PROFILE MM 40x35 PVC LG 550/STARPOL ECO TOP COVER WINDOW IN MICRO-PERFORATED MATERIAL PVC GABLE END WITH WINDOW IN MICRO-PERFORATED MATERIAL PVC BUCKLE...
STARPOL ECO BOX TUNNEL ECO Yarn Warp:100% PES/1100 Dtex Weft:100% PES/1100 Dtex Fabric’s weight Ca 610 gr/m Finishing PVC coated Breaking strength Warp: ca. 235 DaN/5 cm (DIN 53354) Weft: ca. 220 DaN/5 cm Tear strength Warp: ca. 23 DaN (DIN 53363) Weft: ca.
3.3. Installation Before starting the installation, if electrical equipment utilization is needed: • make sure you do not work in wet areas • use only intact extension cords, according to the place of use • use shoes with rubber soles ATTENTION: It is necessary for the operators to use appropriate personal protective equipment such as safety shoes and gloves, in order to avoid injuries provoqued by the fall of the packaging or of components that it contains, perforation and cutting due to...
Page 10
Subsequently, the box must be opened by pushing the crosses from the bottom to the top (photo 4/a and 4/b). The top cover must be stretched: • BASE VERSION: using the stretching device (not included) and tightening the screws of the lower part of the crosses (photo 5/a, 5/b and 5/c) •...
Finally, the box can be fixed to the basement through appropriate anchorage systems. ATTENTION: other installation ways which are not contained in this manual are not allowed, if not previously authorized. ATTENTION: the box must be fixed to the ground and/or to a wall. The installer must verify the ground type and conditions and choose the appropriate anchoring system, also considering the typical meteorological conditions of that particular place (strong wind,…).
5. CHECKS AND MANTAINANCE It is necessary to periodically check the general status of the structure, of the links between components, of the hinges and the top cover. In case of holes or tears in the fabric, damages or cracks of metal components, it is necessary to contact the dealer. The top cover can be washed with neutral detergent and then rinsed with water.
Page 13
Contact information Head office: Dancover A/S For more information Nordre Strandvej 119 G please visit: 3150 Hellebæk www.dancovershop.com Denmark National contact Denmark: 70 26 76 20 Spain: 911 436 828 denmark@dancover.com espana@dancover.com UK: 020 8099 7570 Italy: 02 479 21 198 uk@dancover.com...
Need help?
Do you have a question about the CA119071 and is the answer not in the manual?
Questions and answers