Starting A New Wlan Connection - Ten-Haaft Oyster Connect Extended Operating Instructions

Hide thumbs Also See for Oyster Connect:

Table of Contents

3. COMMISSIONING OF THE MOBILE CONNEC

TIONS / LTE CONNECTION

In the lower left corner of the web page, you can follow the system's status feedback live.

provisionally

- Now the indoor unit will automatically try to find the correct APN settings for your mobile network operator

in a database.

APN stands for Access Point Name. The APN data informs the mobile device where to send its data. If the

data for your mobile network provider is incorrect or unavailable, no data traffic will be possible despite a suc-

cessful connection to the LTE network. The LTE / WiFi LED blinks continuously green to indicate this process.

In such a case, you have the option of correcting the APN data by hand or adding it in the corresponding

fields.

You must ask your mobile network operator for the correct APN data for your SIM card.

- After the LTE connection has been successfully established, four green LEDs should light up continuously on

the front of the Indoor Unit:

4. STARTING A NEW WLAN CONNECTION

4.1 Starting a new WLAN connection

- Go to the start page of the configuration website. (See chapter 3.3, page 7)

On the right screen side you see a window with the title "Outdoor WLAN".

If nothing is displayed there although WLAN networks are within range, please reload the configuration

website via your browser. The WLAN scan was not yet completed. The list is permanently updated auto-

matically. (approximately every 40 seconds).

provisionally

- Select the desired WLAN from the list (in our example: Hot-tenHaaft)

- Your selection is then displayed under "Selected WLAN".

- Now enter the password belonging to this WLAN.

Save & Connect

- Operate the

button.

Table of Contents