Troubleshooting; Cleaning The Filter - Shark WANDVAC WV406ANZ Owner's Manual

MAINTAINING YOUR VACUUM
CLEANING THE DUST CUP (CONTINUED FROM PREVIOUS PAGE)
3. To reinstall, slide the tab on the dust cup into
the slot on the bottom of the nozzle until it
clicks into place.

CLEANING THE FILTER

1. Over a trash can lift the fabric filter by the metal
ring to remove it from the housing, tap lightly
to remove any dust and debris, then rinse with
water only. Let the filter air-dry fully before
reinstalling.
N Z 0 8 0 0 1 1 2 6 6 0 • s h a r kc l e a n . c o . n z
3
1
MAINTAINING YOUR VACUUM

TROUBLESHOOTING

WARNING: To reduce the risk of shock and unintended operation, turn off
power and remove the battery before servicing.
Vacuum turns off on its own.
There are several possible reasons for the vacuum turning off on its own, including blockages, battery
issues, and overheating. If vacuum turns off on its own, perform the following steps
1. Turn on the vacuum and check the battery indicator lights on the hand vacuum. If recharging is needed,
make sure vacuum power is off before plugging in the charger.
2. Empty dust cup and clean the filter. See the Emptying the Dust Cup and Cleaning the Filter sections for
more information.
3. Check wand, accessories, and inlet openings and remove any blockages.
4. Allow unit and battery to cool for at least 45 minutes, until they return to room temperature.
5. Press the On/Off switch to restart the vacuum.
Vacuum is not picking up debris. No suction or light suction.
• Dust cup may be full; empty dust cup.
• Check floor nozzle for blockages; clear blockages if required.
• Remove any string, carpet fibres, or hair that may be wrapped around the brushroll; clear blockages if
required.
• Check filters to see if they need cleaning. See the Cleaning the Filter section for more information.
AU 0 2 8 8 0 1 76 6 6 • s h a r kc l e a n . c o m . a u