Connecting an Antenna or Cable
Making Connections
The TV must receive the signal from one of the following Sources: antenna or CATV network.
Antenna should be placed away from roads, power distribution lines, neon signs and other places, so as to avoid disruption of
television signals, this can prevent accidents from happening. In addition, as long-term exposure outside, antenna prone to
degradation, if the image is not clear, you should first turn off the power, and then check the antenna.
NOTES
・ When using the outdoor antenna, please unplug the cord of the indoor antenna (if any) from the antenna terminal outlet.
・ It is recommended that coaxial cable (75Ω) be used to eliminate the interference caused by the mismatched impedance.
・ The antenna cable should not be bound together with the power cord.
・ When using the CATV or closed circuit TV, please insert the plug of the coaxial cable (75Ω).
Connecting a USB Device
Making Connections
Connect to the USB jack in the TV with USB cable or
directly USB port.
WARNING
All the set's USB jacks to connect external devices while
the total current is not more than 1200 mA. If more than
the output current limit, causing the unit to malfunction,
not covered under warranty.(The USB3.0 device is not
support)
Connecting a SD Device
Making Connections
Connect to the SD jack in the TV with SD card(According
to illustration: keep breach up and toward the jack.
USER MANUAL Connections
Connections
TV JACK
ANT 75Ω
10
|
EXTERNAL DEVICES
ANT OUT
or
TV JACK
TV JACK
EXTERNAL DEVICES
EXTERNAL DEVICES
SD
Card