Defaulting Procedure; Clearing And Defaulting The Receiver; Delete All Users/All Remote Transmitters; Parameter Reset - IDS MKII Installer Manual

2.
2.1
There are three "reset" functions. These enable you to delete all remote users, or restore the factory
default settings for the relay parameters - or perform a complete clear and reset. This only needs to be
done if there are users/remotes that you want to delete. The three options work as follows:
2.2
(All remotes are deleted - Parameter settings are not changed)
Set DIP switches 2, 5, 6, 7, and (lastly) 8.
Clear DIP switch 8 to delete all the remotes.
Clear all remaining switches to return to standby mode.
The ARMED LED stays on.
2.3
(Defaults all the parameters - remote buttons are NOT erased)
Set DIP switches 1, 5, 6, 7, and (lastly) 8.
Clear 8 to affect the reset.
Clear all remaining switches to return to standby mode.
The ARMED LED stays on.
2.4
This will restore the receiver to its "as-new" factory default condition, ALL buttons are erased.
Set DIP switch 1, 2, 5, 6, 7, and (lastly) 8.
Clear 8 to restore the factory defaults and erase all remotes.
Clear all remaining switches to return to standby mode.
The ARMED LED stays on.
NOTE:
The above clears the remote receiver's ID that has been assigned to the Alarm Panel. Use the installer
program location 0 to "remove missing devices":
LOCATION 0 Defaulting of the panel or master user code
NOTE:
When erasing remotes or defaulting them, please make sure that the receiver is not connected to the
Alarm Panel at that time. Once you have completed this function, then you may reconnect the receiver to
the panel.

Defaulting Procedure

Clearing and Defaulting the Receiver

Delete All Users/All Remote Transmitters

Parameter Reset

Erase Remotes and Restore Factory Default

[#] [INSTALLER CODE] [*] [0] [*] [4] [*] and [#] to exit
IDS Digital Remote Receiver MKII 700-373-02C Issued April 2010 6