Table of Contents
Advertisement
Physical installation
Warning! If suspending the product above ground level, secure it against failure of primary
attachments with a safety cable that is approved for the weight of the product.
Warning! If suspending the product from a truss, use 2 clamps to rig the product. Do not use only
one rigging clamp.
Clamping the product on a truss
The P3 PowerPort 1000 IP can be clamped to a truss or similar rigging structure with two clamps bolted
through the clamp attachment points in the mounting bar. See Figure 1. It is intended to be installed hanging
down vertically, as shown in Figure 2. This orientation provides maximum protection from moisture.
When rigging the device hanging vertically from a truss, you can use open-type clamps such as G-clamps.
When installing in any other orientation, you must use closed-type rigging clamps such as half-coupler
clamps (see Figure 3) that completely encircle the truss chord.
Physical installation
7
Advertisement
Table of Contents
