Advertisement
Operating Guide
Pairing the Doorbell with the Speaker
1.
Press the Code button on the rear of the Speaker with a paperclip or similar object.
2.
Press the Doorbell button. The Speaker will confirm pairing by playing a "Ding-Dong" sound.
Resetting the Speaker
First, remove 1 of the 3 batteries from the Speaker's battery compartment. Before installing the
last battery, press and hold the Code button while installing the last battery until a "Ding-Dong"
sound is heard. This clears the pairing information. You will need to pair the Doorbell unit again.
Mounting the Doorbell Unit
The Doorbell is mounted by sticking it to a wall using the included adhesive strip.
The Doorbell is neither water nor weatherproof, and must be installed in a sheltered location.
Exposure to rain, moisture or direct sunlight will adversely affect the performance and durability
of the doorbell.
1. Find the area you want to mount the Doorbell unit. Flat, smooth surfaces are ideal. Make sure
the surface is clean and dry before mounting.
2. Avoid mounting the Doorbell unit on metal surfaces as this may reduce the transmission range.
3. Peel off the covering of the adhesive strip, and attach the Doorbell unit to the wall in the location
you want.
Mounting the Speaker Unit
If you would like to mount the Speaker, simply attach a screw to the wall. Depending on the
surface, you may need to drill guide holes and/or use masonry plugs or dry wall anchors.
Do not insert the screw all the way. Leave about 7mm / ¼" protruding from the wall. Then place
the unit onto the screw, ensuring the head of the screw passes through the mounting hole on the
rear of the unit.
Troubleshooting
The Speaker does not work...
•
Check that the units are within 50 meters range of each other. Try placing the Speaker in
another location nearer to the Doorbell.
•
Check that batteries are fitted correctly with matching polarity.
•
Batteries could be flat and need to be replaced. Use alkaline batteries only.
The Speaker plays the chime when the Doorbell button has not been pressed...
•
Check that the Speaker is not being triggered by another remote like a garage door opener or
similar wireless remote device.
•
Reset the Speaker and pair the Doorbell unit again.
•
Batteries could be running low. Try installing fresh batteries in the Speaker unit.
3
Advertisement
