Advertisement
Operating Guide
Overview
Speaker unit
Installing Batteries
A.
Speaker Unit
•
The Speaker unit requires 3 x AA batteries (not included) to operate. For best performance, use
fresh, high quality AA alkaline batteries.
•
To install them, unclip the battery cover on the rear of the Speaker to reveal the battery
compartment. Insert batteries according to the polarity markings (+ and –) indicated inside the
battery compartment.
B.
Doorbell Unit
WARNING! This product contains button/coin cell batteries. If the button/coin cell battery is swallowed,
it can cause internal chemical burns in as little as two hours and lead to death. Dispose of used
batteries immediately. Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
Australia: If you think batteries might have been swallowed or placed inside any part of the body,
immediately call the 24-hour Poisons Information Centre on 13 11 26 for fast, expert advice and go
straight to the nearest hospital emergency room.
•
The Doorbell unit is powered by 3 x LR44 1.5V alkaline batteries which come pre-installed.
•
To activate the batteries:
1. Remove the nameplate cover by lifting it off then remove the screw at the base of the
Doorbell unit with a small Philips® screwdriver.
2. Insert a small flat-head screwdriver into the small notch above the screw hole at the base of
the Doorbell unit and lift the front cover off.
3. Remove the plastic tab from the battery holder then snap the front cover back onto the
Doorbell unit and fasten with the previously removed screw.
•
Replacement of the batteries is necessary as soon as the LED indicator stops flashing when
the Doorbell button is pressed.
Changing the Chime
•
Remove the front cover of the Doorbell unit (as previously described above
in
"Installing Batteries - Doorbell
•
Inside the Doorbell unit, locate the Chime Select button as shown on the
right. Press the Chime Select button to play the next tune on the Speaker.
Keep pressing the button until you hear a tune you like. There are 38 tunes
to choose from. You do not need to confirm your selection. The tune playing
is the chime selected and the one that will be heard when the Doorbell
button is pressed.
•
Snap the front cover back onto the Doorbell unit and fasten with the screw.
2
Code Button
Battery
Compartment
Unit").
Doorbell unit
Button
Nameplate
cover
Front Cover Off
Chime
Select
Button
Advertisement
