Preparing Work For Installation - LG ARNU123SFA4 Installation Manual

Preparing Work for Installation

Open panel front
1. Pull the upper part of the front panel.
2. Lift up the panel.
3. To detach the front panel, remove the two screws at the lower part.
4. Detach the front panel from the body.
5. To detach the panel, disconnect the connector at the upper part.
Remove cover pipe and cover side
1. Please remove the screw of the center tuning cover.
2. Pull up the side cover of desired connecting direction, then
cover side is separated.
3. Pick the pipe hole of the side cover.
CAUTION: After removing the pipe hole,
cut the burr for safety.
Notice
When making pipe path through rear
wall, you don't need to pick the pipe hole.
Drain hose junction
1. Remove the rubber cap in the desired drain direc-
tion.
2. Insert drain hose into the handle of drain pan, and
join drain hose and connecting hose according to
the figure by.
Comm. PCB
Connector
Pipe hole
Side cover
Adhesive
Connecting
part
Drain
hose
Installation Manual 9
Installation
Panel Front
Connector
Comm. PCB
Connector
Only the Only the
desired direction
desired direction
rubber cap