Table of Contents
Advertisement
Installation
Check
1. Compare the flared work with the figure by.
2. If a flared section is defective, cut it off and do flar-
ing work again.
Connecting the Piping
Indoor
Preparing the indoor unit's piping and drain hose for installation through the wall.
1. Route the indoor tubing and the drain hose in the
direction of rear left or right
2. Tape the tubing, drain hose and the connecting
cable. Be sure that the drain hose is located at the
lowest side of the bundle. Locating at the upper side
can cause drain pan to overflow inside the unit.
CAUTION: If the drain hose is routed inside the room, insulate the hose with an
insulation material* so that dripping from "sweating"(condensation) will not
damage furniture or floors.
*Foamed polyethylene or equivalent is recommended.
12
Indoor Unit
Smooth all round
Inside is shiny without scratches
= Improper flaring =
Inclined
Surface
damaged
Even length
all round
Drain hose
Gas side piping
Connecting
cable
Liquid side piping
Drain hose
Cracked Uneven
thickness
Loop
Advertisement
Table of Contents
