Supra BLIZ'R 2600 Manual page 16

- Please discharge water in the machine accor-
ding to chapter "water drainage".
WATER DRAINAGE:
- When the inner water tank is full, its indicator
will flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off
the machine and restart it , the machine will
runs normally .
- This model have self evaporative function,
under cooling mode, please do not use continue
drainage to get better cooling effect.
- Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (a) on/off
- Unplug the appliance from the mains.
- Unplug the appliance from the mains and allow
it to cool down before starting any cleaning
operation.
- Clean the electrical assembly and the mains
plug with a damp cloth and dry them after-
wards. NEVER SUBMIT THEM IN WATER OR
ANY OTHER LIQUID.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
Problem
Product is not working
Seems device is not
working
Devide noise too loud
Compressor is not
working
Detection codes
E1/E2:
FL:
Causes
No llega corriente.
Indicador de llenado de agua
iluminado
Windows or doors are open
Dirty filter
Air inlet or outlet are block
Room temperature is lower
than the programated
Device is not in a flat surface
Overheat protection is activa-
ted
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap. If the appliance
is not maintained in good condition
- Cleaning, its surface can be degraded and inex-
orably affect the life of the appliance and lead to
a dangerous situation.
CLEANING THE AIR FILTER:
- Clean the air filters every 2 weeks. If the air
filter is blocked with dust, its effectiveness will
be reduced.
- Washing the air filters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry completely
in a shady place.
- Install the filters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.
- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
- If any fault is detected, refer to the following
table:
Solutions
Switch on device
Empty water tank
Start device after empty water tank
Close courtains
Close windows
Clean or change air filter
Clean container
Change temperature setting
Change device in a flat surface
Switch on device after 3 minutes, when
temperature is lower
Meaning
Temperature sensor problem
Water tank full