Supra BLIZ'R 2600 Manual page 15

- The appliance should be used with its wheels
attached.
ASSEMBLY OF THE EXHAUST HOSE
- Lengthen one head of the hose, and spin the
exhaust hose into exhaust connector (counter-
clockwise).
- Caution: Exhaust pipe is 40 cm~160 cm long
(including adapter).
- The length of exhaust pipe is especially desig-
ned in accordance with the specification of the
air conditioner. Please do not use other exhaust
pipes of different lengths or materials, in such
way failure may be caused.
INSTALLATION OF WINDOW KIT (Fig 3)
- Partially open the window and then fix the win-
dow kit to the window.
- The window kit can be installed on most of
normal and vertical windows and it is adjustable.
- Fix the other end of the heatexhausted hose to
the airoutlet window kit.
INSTRUCTIONS FOR USE
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Press the ON/OFF button, the unit will enter in
cooling mode with low fan speed.
- Press the mode button to select cooling dehumi-
difying, fan mode.
FAN SPEED
- Under the cooling and the fan mode, the speed
goes as follow:
- Lower Fan→Mid Fan→High Fan.
- In dehumidifier mode, the fan operates at low
speed.
TIMER MODE
- The operating time of the device can be contro-
lled from 1 ~ 24h.
- Push the button
- You can program the time with the up and down
buttons.
- The timer self-off function is only available when
the device is on.
- The button (up) up and (down) down is used to
set the temperature and the timer.
- In cold mode and heat mode, the temperature
programming arc ranges from 16º ~ 30ºC.
SWING
- Press this button to control the movement of the
louver.
COOLING MODE:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature in a
range of 16~30°C (60,8~86°F).
- When the up or down is pressed once, tempera-
ture will go up or down by 1ºC every time.
- Pressing Up and Down at the same time, we
will alternate between degrees Fahrenheit and
degrees Celsius.
- Press speed to select high, mid or low fan
speed.
FAN MODE:
- Press mode to select fan mode fan indicator
turns on.
- Temperature is not adjustable.
- Press Swing to turn off or turn on the up/down
swing function.
DEHUMIDIFYING MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Remove the plug of drainage cap, insert a tube
and put the other side of the tube into water
containers or drain channels.
- When entering dehumidification mode, if the
room temperatures is ≥17ºC, the compressor
will start to work.
- If the room temperature is ≤15ºC, compressor
stops; when the temperature rises back to
≥17ºC, the compressor restarts (the compres-
sor shall meet the 3minute delay protection
function).
- In dehumidification mode, the fan run in low
speed by default, and the wind speed are not
adjustable. ·Temperature cannot be set.
- NOTE: When the dehumidification function
is in use, the exhaust pipe assembly shall be
removed; otherwise it will lead to not obvious
dehumidification effect or display "FL" water full
alarm.
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.
WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.