pro user RPC3600 Manual page 5

13. The reverse light sockets on most vehicles have two wires connected to them. Usually
the negative wire is black and the positive wire is a colored wire. If you are uncertain
about the wiring, you can use a 12 volt multimeter available at most auto parts
stores to determine which is the positive wire. Follow the manufacturer's instructions
for the safe use of the multimeter.
14. After determining which wire is the positive and which is the negative, turn off the
ignition key, then remove the battery's negative cable.
15. Splice the red wire using the supplied in-line wire connectors to the reverse light's
positive (+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good
connection.
16. Next splice the black wire of the transmitter box power cable to the reverse light's
negative (-) wire or ground.
17. Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape.
18. Re-attach the negative battery cable to the battery.
Monitor Installation
When choosing a location to mount the monitor, make sure the
monitor is in an area that will not obstruct your vision while driving.
1. Before mounting the monitor, clean the mounting surface well.
2. Position the suction mount to the smooth surface which suits
your requirement.
3. Press the suction cap against the smooth surface and press the
lock down to attach and fix the mount to the surface.
4