Table of Contents
Advertisement
INSTALLATION
Lamp
1.
Use 'U' shaped mounting plate located to the rear of the lamp to mark where you
want to install the lamp (7) Fig 1.
2.
Make sure this is clear of obstacles such as cables.
3.
Secure lamp to the wall with screws provided.
4.
Carefully route the power cord from the solar panel to the lamp and plug it into the
battery housing input.
5.
Adjust the motion sensor so that it faces the area where motion is most likely to be
detected. You can move it up and down by adjusting the screw on the neck of the
motion detector.
Note:
Lamp unit should be mounted 2-3 metres from the ground to ensure motion detection
is optimised.
Advertisement
Table of Contents
