Table of Contents
Advertisement
INSTALLATION NOTES
1.
The light should be set up at a location where you desire to have extra lighting to
detect persons or objects moving at night or in the dark. Decide an idea location
prior to installing.
2.
Decide where you want to place both the lamp (1) and solar panel (2). The light is
equipped with 5 metres of connecting wire, so the lamp (1) and solar panel (2) can
be installed up to 5 metres apart.
3.
The solar panel (2) must be set in a location that receives full, direct sunlight a
minimum of 8 hours a day. A wall or roof are ideal locations.
4.
Mount the lamp (1) 2-to-3 metres above ground on a solid surface capable of
supporting the lamp (1), and secure enough so that it will not move when exposed
to vibration or wind. The unit must be high enough to allow for motion detection
and light distribution.
5.
Using the mounting plate as a template, mark certain that the drilling path is clear
of obstacles such as cable and electrical line. Place mounting bracket (7) on drilled
holes and thread in the enclosed mounting screws to secure mounting bracket in
position.
6.
Follow the above steps (steps 4 and 5) to install the solar panel (2).
7.
Carefully route the power cord of the solar panel (2) to the lamp (1) and plug it into
the battery housing outlet (9).
8.
Adjust the motion detector head (6) below the light by moving it left or right so that
it faces the area where movement will occur. Move it up or down by using the screw
located on the neck of motion detector head (6).
Advertisement
Table of Contents
