Functional Description - Makita 9564PC Instruction Manual

WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Shaft lock
1
► 1. Shaft lock
CAUTION:
• Never actuate the shaft lock when the spindle is
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
1
► 1. Lock-off lever 2. Switch lever
CAUTION:
• Before plugging in the tool, always check to
see that the switch lever actuates properly and
returns to the "OFF" position when released.
• Do not pull the switch lever forcibly without
pushing in the lock-off lever.
To prevent the switch lever from accidentally pulled, a lock-off lever
is provided. To start the tool, pull the lock-off lever toward the opera-
tor and then pull the switch lever. Release the switch lever to stop.
Speed adjusting dial
► 1. Speed adjusting dial
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained
when it is turned in the direction of number 1.
Refer to the below table for the relationship between the num-
ber settings on the dial and the approximate rotating speed.
For 9564PCV, 9565PCV
Number
For 9566PCV
Number
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded and heated up.
• The speed adjusting dial can be turned only as
far as 5 and back to 1. Do not force it past 5 or
2
1, or the speed adjusting function may no longer
work.
The tools equipped with electronic function are easy to
operate because of the following features.
6 ENGLISH
min
1
2
3
4
5
min
1
2
3
4
5
1
(R.P.M.)
-1
2,800
4,000
6,500
9,000
12,000
-1 (R.P.M.)
4,000
5,000
6,500
8,000
10,000