Casada braintronics ALPHASONIC II Manual page 8

Table of Contents

Starting up

c) Tighten the R-bolts on the other side of the footrest as shown in Illustration 3.

d) Assembly complete (Illustration 4)

Illustration 3

NOTE

• To avoid injuries and damage to the product, the footrest should not be lifted from the

outside or pressed down. (Illustration 1)

• In order to avoid sitting in an uncomfortable position, make sure that the massage

mechanism has not stopped in an upright position in the seat cushion. Fig 2:

Illustration 1

3 – FITTING AND USING THE HEAD AND BACKREST CUSHION

Please connect the backrest cushion as shown in (Illustration 1) using the practical zipper on

the massage chair. Please fasten the pillow using the Velcro strips on the upper part of the

back cushion (Illustration 2). To clean the backrest cushion, you can easily separate it from

the chair by pulling the zipper. We would strongly advise that you do not use the massage

chair without the backrest cushion.

Illustration 4

Illustration 2

Zipper

Velcro strip

(1)

(2)

Starting up

4 – FLOOR PROTECTION

In order to prevent excessive wear and tear of your floor covering due to the heavy weight

of the massage chair, we recommend placing carpet or similar underneath the chair.

NOTE

The massage chair should not be pushed over uneven or delicate floor surfaces, but should

be carried by at least 2 people. To do this, lift the chair using the handle on the back section

and the footrest. This way the footrest is completely folded up.

5 – SWITCHING ON THE POWER SUPPLY

Connection

procedure

Electrical power switch

Bac k St re

Table of Contents