Changing Engine Oil - Kubota Z482-E Operator's Manual

14 PERIODIC SERVICE
4. If the oil level is too low, remove the oil filler plug, and
add new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes same time for the oil to
come down to the oil pan.
Engine oil quantity
Oil pan depth
Models
*101 mm (3.98 in.) 121 mm (4.76 in.)
Z482-E
2.1 L
2.5 L
(0.55 U.S.gals.) (0.66 U.S.gals.)
0662-E
3.2 L 3.8 L
0722-E (0.84 U.S.gals.) (1 .0 U.S.gals.)
0782-E
3.6 L
-
(0.95 U.S.gals.)
101 mm (3.98 in.)
Z602-E
2.5 L
-
(0.66 U.S.gals.)
101 mm (3.98 in.)
0902-E
3.7 L
-
(0.98 U.S.gals.)
*101mm(3.98in.) oil pan depth is optional.
Oil quantities shown are for standard oil pans.
IMPORTANT:
• Engine oil should be MIL-L-2104C or have properties
of API classification CD grades or higher.
Change the type of engine oil according to the ambient
temperature.
above 25° C (Tl° F)
SAE30 or SAE10W-30
SAE10W-40
0°
c
to 25°
c
(32° F to 77° F)
SAE20 or SAE10W-30
SAE10W-40
below 0° C (32° F)
SAE10 or SAE10W-30
SAE10W-40
• When using oil different from the previous one, be sure
to drain all the previous oil before adding the new
engine oil.
•Changing engine oil
A
CAUTION
To avoid personal injury:
• Be sure to stop the engine before draining
engine oil.
• When draining engine oil, place some
container underneath the engine and dispose it
according to local regulations.
• Do not drain oil after running the engine. Allow
engine to cool down sufficiently.
1. Change oil after the initial 50 hours of operation and
every 100 hours thereafter.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil easier and completely
while the engine is hot.
I)
1ABAAAAAP 1340
(1) Oil drain plug
3. Add new engine oil up to the upper limit of the oil level
gauge.