Table of Contents
Advertisement
4.4
Operating the Laser in standard mode
1.
Turn on the ABT 8000 by pressing the
a.
After displaying the welcome page, the main page with all the available recording
features will be shown on the built-in screen.
b.
There are two additional buttons below the
height measurements, Stagger readings) and
The readings taken in standalone mode (without use of App) are not saved in the
DLLHS. The user will need to document these readings manually.
4.5
Measuring Height & Stagger
1.
Ensure vertical beam is in the operating position.
2.
Press 'M' to turn on the measurement laser. The laser will stay turned on for 1 minute and
during this time the user can position the DLLHS gauge to the measurement location.
3.
Look through the view finder on the vertical beam to view a red LED guide dot (shown in
Figure 6). This will assist the user in aligning the measurement laser with the OHL.
button on the vertical beam.
Figure 5 – Built-in display
button, these are the
R
(REFOS measurement Left/Right).
M
(OHL Laser
7
Advertisement
Table of Contents
